HP 6125XLG - Disabling BGP to Establish a Session to a Peer or Peer Group

237
Step Command Remarks
1. Enter system view.
system-view N/A
2. Configure an IPsec transform
set and a manual IPsec
profile.
See Security Configuration Guide.
By default, no IPsec transform set or
manual IPsec profile exists.
3. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
Use either method.
4. Apply the IPsec profile to an
IPv6 BGP peer or peer group.
peer { group-name |
ipv6-address } ipsec-profile
profile-name
By default, no IPsec profile is
configured for any IPv6 BGP peer
or peer group.
This command supports only IPsec
profiles in manual mode.
Disabling BGP to establish a session to a peer or peer group
This task enables you to temporarily tear down the BGP session to a specific peer or peer group so that
you can perform network upgrade and maintenance without needing to delete and reconfigure the peer
or peer group. To recover the session, execute the undo peer ignore command.
To disable BGP to establish a session to a peer or peer group (IPv4):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Disable BGP to establish a
session to a peer or peer
group.
peer { group-name | ip-address }
ignore
By default, BGP can establish a
session to a peer or peer group.
To disable BGP to establish a session to a peer or peer group (IPv6):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A