HP 6125XLG - Advertising a Host Route

79
Configuring OSPF to redistribute a default route
The import-route command cannot redistribute a default external route. Perform this task to redistribute a
default route.
To redistribute a default route:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Redistribute a default
route.
default-route-advertise [ [ [ always |
permit-calculate-other ] | cost cost |
route-policy route-policy-name | type
type ] * | summary cost cost ]
By default, no default route is
redistributed.
This command is applicable
only to VPNs. The PE router
advertises a default route in a
Type-3 LSA to a CE router.
Configuring default parameters for redistributed routes
Perform this task to configure default parameters for redistributed routes, including cost, tag, and type.
Tags indicate information about protocols. For example, when redistributing BGP routes, OSPF uses tags
to identify AS IDs.
To configure the default parameters for redistributed routes:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Configure the default
parameters for
redistributed routes (cost,
upper limit, tag, and
type).
default { cost cost | tag tag | type type } *
By default, the cost is 1, the tag
is 1, and the type is Type-2.
Advertising a host route
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
N/A
3. Enter area view.
area area-id
N/A
4. Advertise a host route.
host-advertise ip-address cost
By default, no host route is
advertised.