HP 6125XLG - IS-IS Route Redistribution Configuration Example

164
001 Up Down 1497 L1/L2 No/No
# Display information about IS-IS neighbors and interfaces on Switch D.
[SwitchD] display isis peer
Peer information for IS-IS(1)
----------------------------
System Id: 0000.0000.0001
Interface: Vlan-interface100 Circuit Id: 0000.0000.0001.01
State: Up HoldTime: 9s Type: L2 PRI: 100
System Id: 0000.0000.0002
Interface: Vlan-interface100 Circuit Id: 0000.0000.0001.01
State: Up HoldTime: 28s Type: L2 PRI: 64
[SwitchD] display isis interface
Interface information for IS-IS(1)
----------------------------------
Interface: Vlan-interface100
Id IPv4.State IPv6.State MTU Type DIS
001 Up Down 1497 L1/L2 No/No
IS-IS route redistribution configuration example
Network requirements
As shown in Figure 42, Switch A, Switch B, Switch C, and Switch D reside in the same AS. They use IS-IS
to interconnect. Switch A and Switch B are Level-1 routers, Switch D is a Level-2 router, and Switch C is a
Level-1-2 router.
Redistribute RIP routes into IS-IS on Switch D.
Figure 42 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)