HP 6125XLG - Page 214

202
Ste
p
Command Remarks
3. Create an EBGP peer group.
group group-name external
By default, no EBGP peer group is
created.
4. Create an IPv6 BGP peer and
specify its AS number.
peer ipv6-address as-number
as-number
By default, no IPv6 BGP peer is
created.
5. Add the peer into the EBGP
peer group.
peer ipv6-address group
group-name [ as-number
as-number ]
By default, no peer exists in the
peer group.
The as-number as-number option,
if used, must specify the same AS
number as the peer ip-address
as-number as-number command.
6. (Optional.) Configure a
description for the peer group.
peer group-name description
description-text
By default, no description is
configured for the peer group.
7. Create the BGP IPv6 unicast
address family or BGP-VPN
IPv6 unicast address family
and enter its view.
address-family ipv6 [ unicast ]
By default, the BGP IPv6 unicast
address family or BGP-VPN IPv6
unicast address family is not
created.
8. Enable the router to exchange
IPv6 unicast routing
information with peers in the
specified peer group.
peer group-name enable
By default, the router cannot
exchange IPv6 unicast routing
information with the peers.
To configure an EBGP peer group by using Method 3 (IPv4):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Create an EBGP peer group.
group group-name external
By default, no EBGP peer group is
created.
4. Add a peer into the EBGP
peer group.
peer ip-address group group-name
as-number as-number
By default, no peer exists in the
peer group.
5. (Optional.) Configure a
description for the peer group.
peer group-name description
description-text
By default, no description is
configured for the peer group.
6. Create the BGP IPv4 unicast
address family or BGP-VPN
IPv4 unicast address family
and enter its view.
address-family ipv4 [ unicast ]
By default, the BGP IPv4 unicast
address family or BGP-VPN IPv4
unicast address family is not
created.
7. Enable the router to exchange
IPv4 unicast routing
information with peers in the
specified peer group.
peer group-name enable
By default, the router cannot
exchange IPv4 unicast routing
information with the peers.
To configure an EBGP peer group by using Method 3 (IPv6):