HP 6125XLG - Page 243

231
Ste
p
Command Remarks
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Configure the keepalive
interval and hold time.
• Configure the global keepalive
interval and hold time:
timer keepalive keepalive hold
holdtime
• Configure the keepalive
interval and hold time for a
peer or peer group:
peer { group-name |
ip-address } timer keepalive
keepalive hold holdtime
Use either method.
By default, the keepalive interval is
60 seconds, and hold time is 180
seconds.
The timer command takes effect on
new BGP sessions and does not
affect existing sessions.
If you modify the timers with the
peer timer command, BGP
immediately closes the existing
BGP session and creates a new
session to the peer by using the
new settings.
To configure the keepalive interval and hold time (IPv6):
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Configure the keepalive
interval and hold time.
• Configure the global keepalive
interval and hold time:
timer keepalive keepalive hold
holdtime
• Configure the keepalive
interval and hold time for a
peer or peer group:
peer { group-name |
ipv6-address } timer keepalive
keepalive hold holdtime
Use either method.
By default, the keepalive interval is
60 seconds, and hold time is 180
seconds.
The timer command takes effect on
new BGP sessions and does not
affect existing sessions.
If you modify the timers with the
peer timer command, BGP
immediately closes the existing
BGP session and creates a new
session to the peer by using the
new settings.