Figure 9 HSV450 controller rear view
2. Unit ID1. Serial port
4. Fault indicator3. Controller health
6. DPI ports5. Power
8. Fiber ports7. Mirror ports
10. Power supply 29. Power supply 1
Figure 10 Controller front view
2. Battery 21. Battery 1
4. Blower 23. Blower 1
6. Status indicators5. Operator Control Panel (OCP)
7. Unit ID
Operator control panel
The operator control panel (OCP) provides a direct interface to each controller. From the OCP you
can display storage system status and configuration information, shut down the storage system,
and manage the password.
The OCP includes a 40-character LCD alphanumeric display, six push-buttons, and five status
indicators. See Figure 11 (page 15).
HP P6000 Command View is the tool you will typically use to display storage system status and
configuration information or perform the tasks available from the OCP. However, if HP P6000
Command View is not available, the OCP can be used to perform these tasks.
14 EVA6400/8400 hardware
To Next Page
Loading...
