Turning on power
Turn the camera on by sliding the
• ON/OFFswitch to the right and then
releasing it. The Memory/USB light will
blink and then turn off when the camera
is ready.
R÷storlng previous settings
Some of the camera settings do not remain setwhen the
camera isturned off. To restoreall camera settings that were in
effect when the camera was last turned off, hold down the OK
button when you turn on the camera.
Choosing the anguag÷
The first time you turn the camera on, the following screen
appears and prompts you to choose a language.
] Scroll to the language that you
want by using the ,_ _T' buttons.
2 Pressthe OK Button to select the
highlighted language.
NOTE If you need to go back and
change this setting later, you can do this in the Setup
menu. See Chapter 6: U_ing the _efup menu on page 67.
18 hp photosmart 730 series user's manual
To Next Page
Loading...
