To Next Page

To Previous Page

Installation Guide

Adapting for cool on-column injection

Figure 8 Needle support assemblies

4. If necessary, reinstall the injector onto the GC.

5. Install the syringe. See your Operation Guide.

6. Rotate the turret clockwise until it stops, then verify the installation by

manually sliding the syringe carriage down until the needle enters the inlet.

530-

(standard)

250-

m/320-

(HP accessory 18599T)

Questions and Answers:

Need help?

Do you have a question about the HP 7683 and is the answer not in the manual?

HP 7683 Specifications

General