HP 7683 User Manual

Installation Guide
Installing the HP G1926A Bar Code Reader
6
Installing the HP G1926A Bar Code Reader
1. Install the HP G1926A Bar Code Reader support bracket under the front of
the tray as shown below. Leave the screws slightly loose. You will tighten
them later.
Figure 4 The Bar Code Reader support bracket
2. Mount the Bar Code Reader onto the front of the tray base by inserting the
two mounting clips on the Bar Code Reader into the mounting slots on the
edge of the tray base. See Figure 5.
Figure 5 Mounting location for the Bar Code Reader
Adjust this space
Mounting screws (2)
Height adjustment screws
Tray
Support Bracket
GC
Mounting clips
Bar code reader

HP 7683 Specifications

General

Brand	HP
Model	7683
Category	Laboratory Equipment
Language	English