To Next Page

To Previous Page

Installation Guide

Configuring your GC

When installation is complete, configure your HP 6890 GC for use with the

HP 7683 Automatic Liquid Sampler.

Refer to the section on injector configuration in your GC Operating Manual for

instructions to set the following:

• front and/or back injector location

• nanoliter enable

• tray enable

• bar code reader position (position 3, enable, and type)

Questions and Answers:

Need help?

Do you have a question about the HP 7683 and is the answer not in the manual?

HP 7683 Specifications

General