HP 8153A - Page 102

The HP 8153A HP IB Capabilities
The HP 8153A interfaces to the HP-IB as defined by the IEEE Standards 488.1
and 488.2. The table shows the interface functional subset that the HP 8153A
Implements.
Ihble 5-1. HP-IB Capabilities
Mnemonic
Fxinclion
SHI Complete source handshake capability
AHl
Complete acceptor handshake capability
T6 Basic talker; serial poll; unaddressed to talk if addressed to listen; no talk only
L4 Basic listener; unaddressed to listen if addressed to talk; no listen only
SKI
Con\plete service req\iest capability
KLl Complete remote/local capability
PPO No parallel poll capability
DCl Device clear capability
DTI Device trigger capability (accepted but ignored)
CO No controller capability
E2 Tristate outputs (except the handshake lines)
HP-IB Display Indicators
There are two indicators that you may see in the display when you are
controlling the HP 8153A over the HP4B.
rMT lights when the HP 8153A is operating over the HP-IB. While
in remote the only key you can use is fLocai'l . If local lockout is
enabled, then you cannot use any keys.
SRQ (service request) indicator shows when the HP 8153A has
requested service.
5-2 Remote Operation