HP 8153A - Y_Max; Comment

You can only select this parameter when AUTOSCAL is set to OFF. When you
select this parameter, the left side character field shows the message Y_MIN. The
right side character Held shows the minimum value for the y-axis of the plot.
■ You edit the y-axis minimum value using the Modify keys. The lower limit is
-SOO.OOdBm. The higher limit is SOO.OOdBm. The displayed value is always
the setting for the minimum.
■ You can press (Edit ] if you have finished editing, or you can press fKie^ or fpr^
to edit the other parameters.
Y^MAX
You can only select this parameter when AUTOSCAL is set to OFF. When you
select this parameter, the left side character field shows the message Y^MAX. The
right side character field shows the maximum value for the y-axis of the plot.
■ You edit the y-axis maximum value using the Modify keyvS. The lower limit is
-SOO.OOdBm. The higher limit is SOO.OOdBm. The displayed value is always
the setting for the maximum.
■ You can press (Edit) if you have finished editing, or you can press (Next) or (Prev)
to edit the other parameters.
COMMENT
When you select this parameter the left side character field shows the message
COMMENT. The right side character field shows the comment string. The comment
string is included so that you can identify the plot.
Note
4
Other applications in the same channel share the COMMENT
paj'ameter. Changing this parameter in the Plot application
affects the Print application.
■ You edit the comment using the Modify keys. There are eight characters in
the comment and each of these can be a number (0 to 9), a math symbol (-,
+), a space, a letter (A to Z), or punctuation symbols (!, ?, ., ,, l,Q,
#, $, */i, *, C, ], or ->). The displayed characters are always the setting for
the comment.
■ You can press (1^ if you have finished editing, or you can press (TI^ or (Pt^
to edit the other parameters.
3-14 Local Control - Menu Mode