HP 8153A - HP-IB Bus Commands

Table 5-3. HP-IB Bus Commands
Command Description
Treatment
DAB
Data byte
Implemented as usual
DCL
Device clear
Sets 8153 into reset state, see
section “The Parser”
EOI
End or identify End is treated as white space
GET
Group execute trigger
Not implemented
GTL
Go to local
Transparent to the parser
IPC Interface clear
Transparent to the parser
LAG
Listen address group Transparent to the parser
L1.0 Local lock out
Transparent to the parser
MLA
My listen address
Not implemented
MTA
My talk address
Not implemented
PPC
Parallel poll config.
Not implemented
PPD
Parallel poll disable Not implemented
PPE
Parallel poll enable
Not implemented
PPU Parallel poll unconfig.
Not implemented
PPOLL
Parallel poll
Not implemented
REN
Remote enable
Transparent to the parser
SDC Selected device clear
See DCL
SPD
Serial poll disable Transparent to the parser
SPE
Serial poll enable Transparent to the parser
TAD
Iklk address
Transparent to the parser
TCT
Take control Not implemented
UNL
Unlisten
Transparent to the parser
UNT
Untalk
Transparent to the parser
Remote Operation 5-5