HP 8153A - Initiate Command Summary

INITiate Command Summary
Command Parameter
INITiate[l|2j
[:IMMediatel
:COKTinuous <boolean>
:CONTinuous?
PROGram Command Summary
Command Parameter
PRDGrara[l|2]
: SELected]
EXEGute
NAME
NAME?
<appIication>
NUMBer
< varname>, < value>
NUMBer? <varname>
STATe
STATe?
C0NTinuGlPAUSe|RUN|ST0P|O|l|2|3
Note
The Logging Application
application
LOGGING
Parameters
■ varname = SAMPLES
1 < value < 600
■ varname » LQGGSTART
value “ li2|3 where
1 means start when the input power-level is above threshold.
2 means start when the input power-level is below threshold.
3 means start immediately.
G-4 Remote Operation