HP 8153A - Page 108

SOURCE:POWER:STATE ON
SOURCE:POWER:WAVELENGTH LOWER
A semi-colon followed by a colon (;:) sets the path back to the root level.
The command can be written in upper case or in lower case.
The components can be typed in full, or they can be shortened. The full version
is in the command table in both upper and lower case letters. The shortened
version of a command is that part which is shown in upper case.
Example The command
SOURCE:POWER:STATE ON
can also be written in lower case as
source:power:state on
or it can be shortened and written as
sour:pow:stat on
Setting the HP-IB Address
You can only set the HP-IB address from the front panel. See “ADDRESS” in
Chapter 4.
The HP-IB refuses to accept a new HP-IB address if it is in the remote state, or
if it is addressed either as a listener or as a talker. Return the HP 8153A to local
control (via controller) before changing the address.
The default HP-IB address is 22.
5-8
Remote Operation