HP 8153A - Page 131

The Status Commands
The registers and filters described above, are present in each node of the status
structure {the full structure is given later in this chapter). Each node has the
same set of commands and queries. These commands and queries are listed here
once to avoid repetition.
Note
You can only use these commands and queries with a node
specification. The syntax element <node> means any of the
node specifications.
Note
■ The commands and queries are given in upper and lower
case. You can use either the entire command or query (both
upper and lower case), or just the part that is in upper case.
That is, either STATUS:OPERATION:SETTLIHG:EVEMT? or
STAT: OPER: SETT: EVEN? is acceptable.
■ The commands and queries can be entered in either upper
or lower case. That is either STAT:OPER:SETT:EVEN? or
stat:oper:sett:even? is acceptable.
STATusiPRESet
Syntax STATus-.PRESet
Note You do not specify a node with this command.
Description This command presets all the enable registers and
transition filters for all nodes of the OPERational and
QUEStionable status.
The OPERational, QUEStionable, and ISUMmary nodes are
set:
Remote Operation - Status Commands 7-3