HP 8153A - Page 166

SENSe:POWer:RANGe[:UPPER]?
Syntax SENSe[l|2]:P0Wer:RANGe[:UITERl?”
Response <value>
-llOdBm < value < +30dBm
Description This command returns the range setting for the module.
The range is returned as a signed integer (NRl). The
returned value is in dBm. No units are returned in the
response message.
Related Commands SENS: POW: RANG: UPPER, SENS: PDW: RANG; AUTO,
SENS;P0W;RANG:AUTD?
Example OUTPUT 722;"SENS 1:PQW:RANG:UPPER?"
ENTER 722 ;A$
SENSe:POWer:REFerence
Syntax SENS e [ 112]: PC) Wer: REFeren ce ’ ’
<wsp>T0A|T0B|T0REF|0|i|2,<vaiue>[<umt>]
O.OOlpW < value < +9999.9mW
-200dBm < value < +200dBm
with TOREF or 2
unit is PWiNW|UW|MW|Uatt|DBM
-200dB < value < +200dB
with TOA or TQB or 0 or 1
unit is DB
Description This command sets the reference level for this module.
There are two types of reference. One is where the power
being read by the module is expressed relative to this
absolute level:
Result{dB) = Mecisured{dBm) - Reference{dBrn)
Where the Measured value includes any calibration factor.
You select this by using TOREF (or 2) and the value for
the reference as a floating point number (NRf), with the
8-16 Remote Operation ■ Commands