HP 8153A - Page 175

Example
OUTPUT 722; "SOUR:POW: STAT OFF"
SOURce:POWer:STA'Ite?
Syntax SOURc6[l|2];POWer:STAlfe?”
Response <boolean>
Description This command returns the current setting for the state of
the source. 0 means that the source is disabled. 1 means
that the source is enabled.
Related Commands SOUR: POW; STAT
Example OUTPUT 722; "S0URc2 : POW : STAT? "
ENTER 722 ;A$
SOURce:POWer;WAyElength
Note This command only works with dual wavelength sources.
Syntax S0URce[lj2]:POWer:WAVElength”
<wsp>UPPer|L0WerjB0TH
Description This command sets the wavelength of the output signal.
You specify the choice as UPPer for the longer of the
two wavelengths, LOWer for the shorter of the two
wavelengths, or BOTH if the two wavelengths are to be
enabled together.
Related Commands SOUR:POW:WAVE?
Example
OUTPUT 722; "SOUR :PQW: WAVE UPP"
Remote Operation ■ Commands 8-25