HP 8153A - Page 194

Example 3
Description
Line No.
10 to 70
80
90
100
no
130 to 140
150 to 200
Declarations and initializations.
Disable common status interrupts.
Clear the status.
Set the sensor units to Watts and make sure that automatic
ranging is in operation.
Switch on continuous triggering.
Take a reading from the sensor using fetchl :pow. The
triggering for this command is provided by the continuous
trigger.
Check to see if the new reading is the same as the last one. If
it is, increment the count of double readings. Store the new
reading for the next time round. Display the current reading,
the total number of readings, and the number of double
readings.
10-5 Remote Operation • Programming Examples