HP 8153A - Page 202

10
Example 6
400 GOTO Exit
4i0 i
420 Pmm.srq: Appl_ready=l
430 OUTPUT Pmm;''*018"
440 ENABLE INTR 7
460 RETURN
460 f
470 Exit: END
Description
Line No.
20 Sets up where the program goes on the receipt of an interrupt
from the HP4B.
no Reset and clear the instrument, then enable the interrupt from
the Master Summary Status bit.
120, 130
Enable the interrupt from the OPERationiPROGram node.
140 Set the acquisition time and the units for the results.
150
Select the application.
160 Set the parameter.
190 Run the application.
200
Enable the interrupt.
220, 230
Put the program into a loop. The exit condition for this loop is
fulfilled in the interrupt service subroutine.
280, 290
Read in the number of samples that were taken.
320, 330 Read in the samples.
350
to 370 Output the sample values to the screen.
420
Set the exit condition for the program loop.
10-14 Remote Operation - Programming Examples