HP 8153A - Page 254

1370
1390, 1400
Read the value.
Return the instrument to local state, and leave the subroutine.
Setting the Filter
The Alter command on the HP 8152A selects between a 2Hz (filter ON) and an
8Hz (Filter OFF) low pass filter.
This filter is not available on the HP 8153A. The filter command in HP 8152A
Compatability mode selects between an averaging time of 500ms (filter ON) and
an averaging time of 200ms (filter OFF).
Switching the instrument into HP 8162A Compatability mode, does not alter the
averaging time. You should use *RST, or a filter ON or OFF command to set the
averaging time to 500ms or 200ms.
H-4 Remote Operation