HP 8153A - Page 262

Specific Error Identifiers
E 4010 Input value exceeds limits
E 4020 Input value below lower limit
E 4030 Registers of the real time clock cannot be read from or written to.
Store and Recall Errors
E 4101 CH EMPTY Store from or recall to an empty slot.
E 4102 MISMATCH Attempt to recall source data into a sensor module, or
sensor data into a source module.
E 4103 NO DATA Attempt to recall data from a location where no data has
been stored, or where the data is unintelligible.
E 4106 MEM FAIL Memory checksum failed.
Plot, Print, Show, and Manual Logging Errors
E 4201 MO DATA There is no data for the application. Another cause could be
that there is not enough data for the results statistics to be calculated.
E 4202 INVALID The data is invalid.
E 4203 TLKOMLY? Plot or print is not possible because the HP~IB is not set to
talk only mode.
Loss Errors
E 4301 CONFIG The Loss application cannot run, because it needs both a
source and a sensor module.
E 4302 CONFIG The Loss application cannot run, because it needs one of the
modules is already being used.
1-2 Error Codes