HP 8153A - Page 264

I
310 Invalid reference mode [e.g. A/A].
410 Real time clock error.
510 Head connection error [head not connected].
610 Error in the low wavelength laser diode current in channel A.
620 Error in the low wavelength laser diode current in channel B.
630 Error in the high wavelength laser diode current in channel A.
640 Error in the high wavelength laser diode current in channel B.
710 Error in the low wavelength monitor current in channel A.
720 Error in the low wavelength monitor current in channel B.
730 Error in the high wavelength monitor current in channel A.
740 Error in the high wavelength monitor current in channel B.
810 Zeroing failed in channel A.
820 Zeroing failed in channel B.
Command Errors
These error codes have numbers in the range -199 to -100. They indicate a
syntax error has been detected by the parser, this could be
■ A syntax error.
■ A semantic error (unrecognised command)
■ A Group Execute Trigger (GET) was put in the input buffer inside a program
message.
The command error bit is set in the Event Status Register, see “*ESR?” in
Chapter 6.
-100 Command error [generic syntax or semantic error].
-101 Invalid character.
-102 Syntax error [unrecognised command or data type).
-103 Invalid seperator.
-104 Data type error [e.g. numeric or string expected, got block data].
-105 GET not allowed.
1-4 Error Codes