HP 8153A - Page 6

The following work should be carried out by a qualified electrician, and all local
electrical codes must be strictly observed. If the plug on the cable does not fit
the power outlet, or if the cable is to be attached to a terminal block, cut the
cable at the plug end and rewire it.
The color coding used in the cable depends on the cable supplied. If you are
connecting a new plug, it should meet the local safety requirements and include
the following features:
■ Adequate load“Oarrying capacity (see table of specifications).
■ Ground connection.
■ Cable clamp.
Operating Environment
Warning
The HP 8153A is not designed for outdoor use. To prevent
potential fire or shock hazard, do not expose the HP 8153A
to rain or other excessive moisture.
Input/Output Signals
Caution
A maximum of 15V can be applied as an external voltage to any
of the BNC connectors.
Vi