HP 8508A - Equipment Required; Post Repair Adjustments

Adjustments
Anti-Static Freezer Spray
.
When attempting to locate a temperature related fault, use only an approved anti-static freezer spray.
Anti-Static Products
Table 5-1 contains details of anti-static products which are available from Hewlett-Packard-~ -
Table 5-1. Anti-Static Products
Product . HP Part Number
Anti-static workstation kit 9300-0792
Metalized Solder Remover 8690-0227
Wrist-strap end cord 9300-0970
5-4 EQUIPMENT REQUIRED
All adjustment procedures contain a list of required test equipment. The test equipment is also identified by callouts
in the test setup diagrams, where included. If substitutions must be made for the specified test equipment, refer to
the Recommended Test Equipment table in section 1 of this manual for the minimum specifications. It is important
that the test equipment meet the critical specifications listed in the table if the Vector Voltmeter is to meet its
performance requirements. ,
Note: Use a non-metallic tool whenever possible (for example, HP Part Number 8830-0024).
5-5 POST REPAIR ADJUSTMENTS
Table 5-2 lists the adjustments related to repairs or replacement of any of the assemblies.
5-2
E1089
ee, BERBER eReR OER ORE FRR ReR Ee Pee eer Fee |