6-7
Error Messages
Error Messages in Alphabetical Order
CORRECTION AND DOMAIN RESET
Error Number
65
When you change the frequency range, sweep type, or number of points,
error-correction is switched off and the time domain transform is recalculated,
without error-correction. You can either correct the frequency range, sweep type,
or number of points to match the calibration, or perform a new calibration. Then
perform a new time domain transform.
CORRECTION CONSTANTS NOT STORED
Error Number
3
A store operation to the EEPROM was not successful. You must change the
position of the write-protect jumper on the A9 CPU assembly. Refer to the
“Adjustments and Correction Constants” chapter of the service guide for
information on the A9 CC jumper position.
CORRECTION ON: AUX CHANNEL(S) RESTORED
Error Number
214
This message is displayed when a calibration is restored and that calibration
previously had one or both auxiliary channels enabled.
CORRECTION TURNED OFF
Error Number
66
Critical parameters in your current instrument state do not match the
parameters for the calibration set, therefore correction has been turned off. The
critical instrument state parameters are sweep type, start frequency, frequency
span, and number of points.
CURRENT PARAMETER NOT IN CAL SET
Error Number
64
Correction is not valid for your selected measurement parameter. Either change
the measurement parameters or perform a new calibration.
D2/D1 INVALID WITH SINGLE CHANNEL
Error Number
130
You can only make a D2/D1 measurement if both channels are on.
D2/D1 INVALID: CH1 CH2 NUM PTS DIFFERENT
Error Number
152
You can only make a D2/D1 measurement if both channels have the same
number of points.
DEADLOCK
Error Number
111
A fatal firmware error occurred before instrument preset completed. Call your
local Hewlett-Packard sales and service office.
To Next Page
Loading...
