HP 8719ET - Page 201

6-8
Error Messages
Error Messages in Alphabetical Order
DEMODULATION NOT VALID
Error Number
17
Demodulation was selected when the analyzer was not in CW time mode. Select
demodulation only after putting the analyzer into CW time mode.
DEVICE: not on, not connect, wrong addrs
Error Number
119
The device at the selected address cannot be accessed by the analyzer. Verify
that the device is switched on, and check the HP-IB connection between the
analyzer and the device. Ensure that the device address recognized by the
analyzer matches the HP-IB address set on the device itself.
DIRECTORY FULL
Error Number
188
There is no room left in the directory to add files. Either delete files or get a new
disk.
DISK HARDWARE PROBLEM
Error Number
39
The disk drive is not responding correctly. Refer to the service guide for
troubleshooting information. If using an external disk drive, refer to the disk
drive operating manual.
DISK IS WRITE PROTECTED
Error Number
48
The store operation cannot write to a write-protected disk. Slide the
write-protect tab over the write-protect opening in order to write data on the
disk.
DISK MEDIUM NOT INITIALIZED
Error Number
40
You must initialize the disk before it can be used.
DISK MESSAGE LENGTH ERROR
Error Number
190
The analyzer and the external disk drive are not communicating properly. Check
the HP-IB connection and then try substituting another disk drive to isolate the
problem instrument.
DISK: not on, not connected, wrong addrs
Error Number
38
The disk cannot be accessed by the analyzer. Verify power to the disk drive, and
check the HP-IB connection between the analyzer and the disk drive. Ensure
that the disk drive address recognized by the analyzer matches the HP-IB
address set on the disk drive itself.