6-16
Error Messages
Error Messages in Alphabetical Order
PARALLEL PORT NOT AVAILABLE FOR COPY
Error Number
167
You have defined the parallel port as general purpose I/O (GPIO) for sequencing.
The definition was made under the key menus. To access the parallel
port for copy, set the selection to .
PHASE LOCK CAL FAILED
Error Number
4
An internal phase lock calibration routine is automatically executed at
power-on, preset, and any time a loss of phase lock is detected. This message
indicates that phase lock calibration was initiated and the first IF detected, but
a problem prevented the calibration from completing successfully. Refer to the
service guide and execute pretune correction test 48. This message may appear
if you connect a mixer between the RF output and R input before turning on
frequency offset mode. Ignore it: it will go away when you turn on frequency
offset. This message may also appear if you turn on frequency offset mode before
you define the offset.
PHASE LOCK FAILURE
Error
Number 7
The first IF signal was detected at pretune, but phase lock could not be acquired.
Check the signal level to the R channel input to make sure it is −35 dBm or
higher. Refer to the service guide for troubleshooting.
PHASE LOCK LOST
Error Number
8
Phase lock was acquired but then lost. Refer to the service guide for
troubleshooting information.
PLOT ABORTED
Error Number
27
When you press the key, the analyzer aborts the plot in progress.
PLOTTER: not on, not connect, wrong addrs
Error Number
26
The plotter does not respond to control. Verify power to the plotter, and check
the HP-IB connection between the analyzer and the plotter. Ensure that the
plotter address recognized by the analyzer matches the HP-IB address set on
the plotter itself.
PLOTTER NOT READY-PINCH WHEELS UP
Error Number
28
The plotter pinch wheels clamp the paper in place. If you raise the pinch wheels,
the plotter indicates a "not ready" status on the bus.
Local
Local
To Next Page
Loading...
