HP Agilent E8491A - Editing the HP E8491 A Resource Manager Configuration; Introduction; Configuration File Overview

Editing the HP E8491A Resource Manager Configuration 69Appendix B
Appendix B
Editing the HP E8491A Resource Manager
Configuration
Introduction
The resource manager functionality provided through the HP E8491A
configures your VXI system based on rules specified by the VXI standard.
The configuration can be viewed or modified through the configuration files
and utility functions outlined in this appendix.
Configuration File
Overview
Configuration files (.cf extension) are placed in the <drive:>\siclnt\defaults
or \sicl95\defaults directory when the HP I_O Libraries are installed. Except
where noted, the following files can be edited from the HP I_O Libraries’
‘I_O Config’ utility (Figure B-1) as shown on the following pages. When
editing a file, note the following:
1. Add your entry(ies) below the commented (lines).
2. The first column must contain an entry. Any number of spaces can
separate remaining entries on the line.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com