Chapter 2
Prepare the ES47 M2 System
Follow these steps for upgrading an ES47 M2 tower to go into a cabinet.
If your ES47 M2 is a cabinet system, go to Chapter 3.
This chapter details the steps to prepare the tower system for insertion into a cabinet.
Sections include:
• Remove the tower system’s panels
• Remove the top, left, and rear frames
• Remove the right and bottom frames
• Remove the fans
• Unplug the IDE cable from the I/O expander
• Remove the OCP
• Reposition the disk/CD unit
• Reposition the OCP
• Reseat the fans
• Close module door
Prepare the System 2-1
To Next Page