HP Apollo a6000 User Manual

Installing the chassis 16
WARNING:
The chassis is very heavy. To reduce the risk of personal injury or damage to the
equipment, do the following:
• Observe local occupational health and safety requirements and guidelines for manual
material handling.
• Get help to lift and stabilize the product during installation or removal, especially when the
product is not fastened to the rails. The chassis weighs more than 25.85 kg (57.00 lb), so at
least four people must lift the chassis into the rack together. An additional person may be
required to help align the chassis if the chassis is installed higher than chest level.
WARNING: To avoid risk of personal injury or damage to the equipment, do not stack
anything on top of rail-mounted equipment or use it
as a work surface when extended from the
rack.
WARNING: To reduce the risk of personal injury or damage to the equipment, be sure that:
• The rack is bolted to the floor using the concrete anchor kit.
• The leveling feet extend to the floor.
• The full weight of the rack rests on the leveling feet.
• The racks are coupled together in multiple rack installations.
•
Only one component is extended at a time. If more than one component is extended, a rack
might become unstable.
CAUTION: Always plan the r
ack installation so that the heaviest item is on the bottom of the
rack. Install the heaviest item first, and continue to populate the rack from the bottom to the top.
CAUTION:
Be sure to keep the product parallel to the floor when installing the chassis. Tilting
the product up or down could result in damage to the slides.
CAUTION:
Hewlett Packard Enterprise has not tested or validated the Apollo a6000 Chassis
with any third-party racks. Before installing the Apollo a6000 Chassis in a third-party rack, be
sure to properly scope the limitations of the rack. Before proceeding with the installation,
consider the following:
• You must fully understand the static and dynamic lo
ad carrying capacity of the rack and be
sure that it can accommodate the weight of the Apollo a6000 Chassis.
• Be sure sufficient clearance exists for cabling, installation and removal of the chassis, and
actuation of the rack doors.
To install the chassis:
WARNING:
To reduce the risk of personal injury or equipment damage, be sure that the rack
is adequately stabilized before installing the chassis.

HP Apollo a6000 Specifications

General

Brand	HP
Model	Apollo a6000
Category	Chassis
Language	English