Installing the chassis 17
1.
Install the chassis into the rack.
2. Secure the chassis to the rack.
Installing the system components
If components were removed during the chassis installation or additional components were ordered,
install each device using the procedures in this section.
If you perform any of the procedures in this section after powering on the chassis, ensure proper airflow by
ensuring that each bay inside the chassis and at the rear of the chassis is populated with either a
component or a blank. For component-specific replacement information, see the Apollo a6000 Chassis
Maintenance and Service Guide or the server-specific user and maintenance guides on the Hewlett
Packard Enterprise website (http://www.hpe.com/info/docs).
Installing a server tray blank
To Next Page
Loading...
Need help?
General