Home

Chassis

Apollo a6000

HP Apollo a6000 User Manual

49 pages

To Next Page

To Previous Page

Installing the chassis 21

CAUTION:

Do not overtighten the screws. Hewlett Packard Enterprise recommends using a

torque of only 2-4 in-lb.

To install the component:

1. Remove the power cage cover.

2. Install the power cables in the power cage.

Default Chapter3
- Table of Contents3
Planning the Installation5
Identifying Components and Leds9
Installing the Chassis15
Cabling27
- Cabling Requirements27
- Cabling the Chassis27
Configuring the System33
- Power Capping33
  - Power Capping Modes33
- Configuring a Power Cap34
  - Setting the Chassis Power Cap Mode with the PPIC Utility34
  - Setting the Chassis Power Cap Mode with APM34
Troubleshooting36
- Troubleshooting Resources36
Electrostatic Discharge37
- Preventing Electrostatic Discharge37
- Grounding Methods to Prevent Electrostatic Discharge37
Warranty and Regulatory Information38
- Warranty Information38
- Regulatory Information38
Specifications40
Support and Other Resources43
Acronyms and Abbreviations45
Documentation Feedback46
Index47

Questions and Answers:

Need help?

Do you have a question about the HP Apollo a6000 and is the answer not in the manual?

HP Apollo a6000 Specifications

General

Brand	HP
Model	Apollo a6000
Category	Chassis
Language	English

Related product manuals

HP Apollo 4510 Gen10

74 pages

HP Apollo a6000 Chassis

407484-B21 - ProLiant Essentials Accelerated iSCSI

7 pages

A4500A - VMEbus Single Board Computer 744 Motherboard

114 pages

HP Apollo a6000 User Manual

Table of Contents

Questions and Answers:

HP Apollo a6000 Specifications

Related product manuals