HP Aruba 8325 Series

14 Aruba 8325 Switch Installation and Getting Started Guide
40 Gbps 40-Gig
Direct Attach
Copper
(twinaxial)
–––––
40-Gig AOC Fiber
(multimode)
–––––
40-Gig SR4 Fiber
(multimode)
–––
MPO
7
–
40-Gig ESR4 Fiber
(multimode)
–––MPO –
40-Gig LR4 Fiber (single
mode)
–––LC –
40-Gig ER4 Fiber (single
mode)
–––LC –
40-Gig Bidi Fiber (single
mode)
–––LC –
100 Gbps 100-Gig
Direct Attach
Copper
(twinaxial)
–––––
100-Gig AOC Fiber
(multimode)
–––––
100-Gig SR4 Fiber
(multimode)
––––MPO
100-Gig LR4 Fiber (single
mode)
––––LC
1
For supported transceivers, see the Transceiver Guide.
For technical details of cabling and technologies, see “Cabling and technology information”
.
2
RJ-45 Cat 5e cable is needed for connecting this transceiver. The max link length specified is 100m.
3
10GBase-T transceiver limited support:
-only supported in ports 1-2, 4-5, 7-8, 10-11, 13-14, 16-17. Use in any other port generates an “Incompatible
interface” error.
-maximum twelve 10GBase-T transceivers (both interface-groups 1 & 2 must be set for 10G operation).
4
RJ-45 shielded Cat 6A cable is needed for connecting up this transceiver. The max link length specified is 30m.
5
CAT6A F/FTP, S/FTP, SF/FTP highly recommended in noisy environments. Refer to Aruba
Support_Advisory_JL563A_10GBaseT_APSC-RS20180403-01 for more information.
6
The Lucent Connector (LC) is a small form factor fiber optic connector.
7
The Multifiber Push On (MPO) connector is a 12-fiber optical connector.
Table 6: Optional network connectivity, speeds, and technologies (Continued)
Transceiver form-factor and connector
1
Speed Technology Cabling SFP ("mini-
GBIC")
Connector
SFP+
connector
SFP28
connector
QSFP+
connector
QSFP28
connector