HP Aruba 8325 Series

42 Aruba 8325 Switch Installation and Getting Started Guide
1GBase-T (J8177D) transceiver support restrictions in the 48-port 8325 switches
Beginning with software release 10.03, the Aruba 8325-48YBC switches also support 1GBase-T (J8177D)
transceivers in all top row and middle row ports. The bottom row ports do not support 1GBase-T (J8177D)
transceiver operation.
Figure 25: 1GBase-T transceiver support for the 48-port 8325 switches
If the switch detects a 1GBase-T (J8177D) transceiver in any bottom row port, the show interface brief
command will list an Incompatible interface for that port.
10GBase-T (JL563A) transceiver support restrictions in the 48-port 8325 switches
Beginning with software release 10.03, the Aruba 8325-48YBC switches also support 10GBase-T (JL563A)
transceivers in the following top row and middle row ports:
Figure 26: 10GBase-T transceiver support for the 48-port 8325 switches
To enable use on ports 13-17, Interface-Group 2 must be set to 10G operation.
Table 26: 1GBase-T transceiver support for the 48-port 8325 switches
Label Description
1 All top row ports support 1GBase-T (J8177D) transceivers.
2 All middle row ports support 1GBase-T (J8177D) transceivers.
3 Bottom row ports do not support 1GBase-T (J8177D) transceivers
Ports not occupied by a J8177D RJ-45 transceiver continue to support optical, DAC, or AOC products.
Table 27: 10GBase-T transceiver support for the 48-port 8325 switches
Label Description
1 Top row ports 1, 4, 7, 10, 13, 16 support 10GBase-T (JL563A) transceivers.
2 Middle row ports 2, 5, 8, 11, 14, and 17 support 10GBase-T (JL563A) transceivers.
3 Bottom row ports do not support 10GBase-T (JL563A) transceivers
Ports not occupied by a JL563A RJ-45 transceiver continue to support optical, DAC, or AOC products.
3
2
1
1 4 7 10 13 16 19 22 25 28 31 34 37 40 43 46
2 5 8 11 14 17 20 23 26 29 32 35 38 41 44 47
3
2
1
1 4 7 10 13 16
2 5 8 11 14 17