3. Remove the four Phillips PM2.0×7.1 screws (2) that secure the top cover/keyboard to the bottom cover.
4. Turn the computer right side up with the front toward you.
5. Open the computer as far as it will open.
6. Use a nonmarking, nonconductive tool (1) to release the rear edge of the top cover/keyboard (2) from the
computer.
7. Release the clear shield (3) that covers the keyboard cable and touchpad cable zero insertion force (ZIF)
connectors on the system board.
8. Release the ZIF connector (4) to which the keyboard cable is connected, and then disconnect the keyboard
cable from the system board.
30 Chapter 5 Removal and replacement procedures for authorized service provider parts ENWW
To Next Page
Loading...
