EOJ Command The EOJ command informs the printer that the job has
completed. Use this command whenever you use the JOB
command.
Note The JOB and EOJ commands are always used in pairs. Do
not use one without the other.
Syntax: @PJL EOJ [NAME = "
job name
"] [<CR>]<LF>
Parameters:
NAME = "job name" — Using the EOJ command, you
can name your print job. The job name variable is a
string and must be enclosed in double quotes as shown in
the command syntax. The job name string need not be
the same name used in the JOB command. If the NAME
option is included, the unsolicited end-of-job status
includes the job name (if unsolicited job status is
enabled).
Comments: The EOJ command marks the end of the job started with
the previous JOB command. The EOJ command:
Resets the PJL Current Environment variables to their
default (NVRAM) values, as if the printer powered down
and then powered up again.
Resets the page number associated with unsolicited page
status.
Parameter Functional Range Default
NAME = "job name" Roman-8 characters
33 thru 255, <SP>,
<HT>
N/A
5-8 Job Separation Commands
To Next Page
Loading...
