HP Color laserjet 5500 - Incorrect printer output

FSUPLOAD
Command
The FSUPLOAD command uploads a file, or a part of a file,
from the printer file system to the host.
Syntax: @PJL FSUPLOAD NAME = " pathname "
~OFFSET=<number> SIZE=<number>[<CR>]<LF>
Response Syntax: If the pathname is valid:
@PJL FSUPLOAD FORMAT:BINARY
~NAME = "
pathname " OFFSET=< number >
~SIZE=<
number ><CR><LF>
<SIZE
bytes of file data >
<FF>
If the pathname is invalid:
@PJL FSUPLOAD NAME = "
pathname "<CR><LF>
FILEERROR=<
number ><CR><LF>
<FF>
Parameters:
NAME = "pathname" — For the FSUPLOAD command,
the variable pathname must be a file name (not a
directory). For a complete description of the NAME
parameter, see NAME = "pathname" on pages 9-2 to 9-3.
OFFSET = integer — The offset variable specifies the
offset, from the beginning of the file, indicating the point
to begin uploading.
Parameter Functional Range Default
NAME="pathname" Roman-8 characters
01 thru 255
N/A
OFFSET=integer 0 to 2
31
– 1 N/A
SIZE=integer 0 to 2
31
– 1 N/A
9-12 PJL File System Commands