FSINIT Command The FSINIT command is used to initialize the printer’s
mass storage file system. This FSINIT command must be
part of a secure job.
Syntax: @PJL FSINIT VOLUME = "
pathname
" [<CR>]<LF>
Parameters:
* Volume 1: is only supported on the LaserJet 4000 printer.
VOLUME = "pathname" — The variable pathname
must be a volume.
Example:
Using the FSINIT
Command
This example demonstrates using the FSINIT command to
initialize volume 0 of the printer file system.
@PJL FSINIT VOLUME = "0:" [<CR>]<LF>
Related Commands: FSAPPEND, FSDELETE, FSDIRLIST, FSDOWNLOAD,
FSMKDIR, FSQUERY, FSUPLOAD, INFO FILESYS
Parameter Functional Range Default
VOLUME = "pathname" 0: or 1:* N/A
9-8 PJL File System Commands
To Next Page
Loading...
