Glossary
~
This character indicates that the current command line is
a continuation of the previous line. For example, “These
~words are all part of the same line.”
|
The vertical bar, when shown in a command, indicates
that either one or the other options may be selected, but
not both.
Active I/O Port
The I/O port which is providing the data for the current
print job. For LaserJet printers with automatic I/O
switching, if there is no current print job, then automat-
ic I/O switching is enabled and all I/O ports are active.
Auto-Continue
If the auto-continue mode is configured to ON, the
printer continues printing during certain non-fatal er-
ror conditions. If auto-continue is OFF and these same
conditions occur, the printer goes off-line until the Con-
tinue or On Line key is pressed. Auto-continue mode
can be configured using the printer’s control panel or us-
ing PJL commands (refer to the user’s manual for the
specific PCL 5 printer).
Glossary-1
To Next Page
Loading...
