EasyManuals Logo

HP Compaq dc7100 DT Technical Reference Guide

HP Compaq dc7100 DT
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #127 background imageLoading...
Page #127 background image
Technical Reference Guide 361834-002 6-1
6
Integrated Graphics Subsystem
6.1 Introduction
This chapter describes graphics subsystem that is integrated into the 82915G/GV GMCH
component. This graphics subsystem employs the use of system memory to provide efficient,
economical 2D and 3D performance.
The SFF, ST, MT, and CMT form factors may be upgraded by installing a graphics card into the
PCI Express x16 or the PCI 2.3 slot. The USDT form factor may be upgraded by installing
graphics card into the PCI 2.3 slot. An installed PCI Express or PCI 2.3 graphics controller card
will be detected by the BIOS during the boot sequence and the integrated graphics controller of
the 82915G GMCH will then be disabled (refer to section 6.5 for more information on upgrading
the graphics subsystem).
This chapter covers the following subjects:
Functional description (6.2), page 6-2
Display Modes (6.3), page 6-5
Upgrading graphics (6.4) , page 6-5
VGA Monitor connector (6.5), page 6-6

Table of Contents

Other manuals for HP Compaq dc7100 DT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Compaq dc7100 DT and is the answer not in the manual?

HP Compaq dc7100 DT Specifications

General IconGeneral
Processor SpeedUp to 3.8 GHz
ChipsetIntel 915G
MemoryUp to 4 GB DDR2 SDRAM
Operating SystemWindows XP Professional
Form FactorDesktop
ProcessorIntel Pentium 4
Storage40 GB to 160 GB SATA
GraphicsATI Radeon X300 SE
Optical DriveDVD-ROM
AudioIntegrated audio
NetworkIntegrated Gigabit Ethernet
Expansion Slots1 PCI Express x16
Ports1 Parallel, 1 Serial, 2 PS/2, 1 VGA

Related product manuals