HP Compaq dc7100 DT Hardware Reference Guide

2–6 www.hp.com Hardware Reference Guide
Hardware Upgrades
To replace the front bezel and MultiBay:
1. Ensure that the front bezel and MultiBay are aligned properly,
then slide the assembly toward the rear of the computer until it is
properly seated. The latch on each side of the computer chassis
will return to its original position.
2. Reconnect the fan cable.
3. Replace the MultiBay daughter card by carefully aligning the
card with the connector slot and pressing the card firmly into
place.
4. Replace the MultiBay drive. Refer to “Inserting a Drive into the
MultiBay” on page 2–33 for more information.
5. Replace the access panel.
6. Replace the stand, if desired.
7. Reconnect all external devices, plug the power cord into the
power outlet, and turn the computer on.
8. Use Computer Setup to enable the Smart Cover Sensor, if desired.

HP Compaq dc7100 DT Specifications

General

Processor Speed	Up to 3.8 GHz
Chipset	Intel 915G
Memory	Up to 4 GB DDR2 SDRAM
Operating System	Windows XP Professional
Form Factor	Desktop
Processor	Intel Pentium 4
Storage	40 GB to 160 GB SATA
Graphics	ATI Radeon X300 SE
Optical Drive	DVD-ROM
Audio	Integrated audio
Network	Integrated Gigabit Ethernet
Expansion Slots	1 PCI Express x16
Ports	1 Parallel, 1 Serial, 2 PS/2, 1 VGA