2–30 www.hp.com Hardware Reference Guide
Hardware Upgrades
6. Slide the catch toward the left side of the computer until it is
engaged.
Engaging the MultiBay Security Catch
7. Replace the access panel.
8. Replace the stand, if desired.
9. Reconnect all external devices, plug the power cord into the
power outlet, and turn the computer on.
10. Use Computer Setup to enable the Smart Cover Sensor, if desired.
To release the MultiBay security catch:
1. If the Smart Cover Sensor is enabled, restart the computer and
enter Computer Setup to disable it.
2. Turn off the computer properly through the operating system,
then turn off any external devices.
3. Disconnect the power cord from the power outlet and the
computer, and disconnect any external devices.
To Next Page
Loading...
