Hardware Reference Guide www.hp.com 2–31
Hardware Upgrades
4. Position the computer on its side with the rubber pads on the
bottom. (If the computer is being used in the tower configuration,
remove the computer from the stand. Refer to “Attaching and
Removing the Tower Stand” on page 2–7 for more information.)
5. Remove the access panel. Refer to “Removing and Replacing the
Access Panel” on page 2–1 for more information.
6. Push the tongue of the catch down 1 and slide the catch toward
the right side of the computer 2 until it is disengaged.
Releasing the MultiBay Security Catch
7. Replace the access panel.
8. Replace the stand, if desired.
9. Reconnect all external devices, plug the power cord into the
power outlet, and turn the computer on.
10. Use Computer Setup to enable the Smart Cover Sensor, if desired.
To Next Page
Loading...
