HP Compaq nc6220 Maintenance And Service Guide

Removal and Replacement Procedures
Maintenance and Service Guide 6–45
2. Position the computer with the right side toward you.
3. Disconnect the serial connector module cable 1 from the
system board.
4. Remove the two HM5.0×11.0 screw locks 2 that secure
the serial connector module to the base enclosure.
5. Remove the serial connector module 3 from the
base enclosure.
Removing the Serial Connector Module and Cable
Reverse the above procedure to install the serial connector
module.

HP Compaq nc6220 Specifications

General

Display	14.1-inch TFT
Maximum Memory	4 GB
Hard Drive Interface	ATA-100
Graphics	Intel Graphics Media Accelerator 900
Operating System	Windows XP Professional
Battery Life	Up to 4 hours
Processor	Intel Pentium M
Display Resolution	1024 x 768
Storage	40 GB
Networking	10/100/1000 Ethernet, 802.11b/g Wi-Fi
Ports	3 x USB 2.0, VGA, RJ-11, RJ-45, headphone/microphone jacks
Optical Drive	DVD-ROM
RAM	512 MB to 2 GB