6. Remove the two retainer screws that secure the drive to the bay (1) then slide the drive forward
and out of the bay (2).
Figure 8-9 Removing a 5.25-inch External Drive
Installing an Optical Drive into the 5.25-inch Drive Bay
To install an optional 5.25-inch optical drive:
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 83).
2. Remove the access panel (
Access Panel on page 84).
3. Remove the front bezel (
Front Bezel on page 85).
4. If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then remove
the bezel blank.
5. Install the guide screw in the front top hole on the left side of the drive.
Figure 8-10 Installing the Guide Screw in the Optical Drive
Drives 93
To Next Page
Loading...
