6. Press the release latch on the chassis base, and then lift up the rear of the power supply to
disengage it from the chassis.
7. Slide the power supply toward the front of the computer, then lift the power supply out of the
computer.
To install the power supply, reverse the removal procedure.
System Board
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
●
Memory modules
●
Processor
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 37).
2. Remove the access panel (
Access Panel on page 38).
3. Lay the computer on its side with the rear facing toward you.
4. Remove the front bezel (
Front Bezel on page 39).
5. Remove an expansion cards (
Expansion Cards on page 45).
6. Disconnect the power, and data cables from the back of all installed drives.
System Board 73
To Next Page
Loading...
