NOTE: The 3.5-inch drive bay may contain a diskette drive or a media card reader.
1. Prepare the computer for disassembly (Preparation for Disassembly on page 83).
2. Remove the access panel (
Access Panel on page 84).
3. Remove the front bezel (
Front Bezel on page 85).
4. Disconnect the data cable (1) and power cable (2) from the rear of the drive.
Figure 8-15 Disconnecting the Diskette Drive Cables
5. Rotate the drive cage all the way up.
Figure 8-16 Rotating the Drive Cage Up
96 Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
To Next Page
Loading...
