EasyManuals Logo

HP dx7300 User Manual

HP dx7300
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #155 background imageLoading...
Page #155 background image
Technical Reference Guide www.hp.com A-3
Error Messages and Codes
514-CPU or Chassis Fan not
detected.
CPU fan is not connected or may have malfunctioned.
601-Diskette Controller Error Diskette drive removed since previous boot.
605-Diskette Drive Type Error Mismatch in drive type.
912-Computer Cover Removed
Since Last System Start Up
Cover (hood) removal has been detected by the Smart Cover Sensor.
914-Hood Lock Coil is not
Connected
Smart Cover Lock mechanism is missing or not connected.
916-Power Button Not Connected Power button harness has been detached or unseated from the system
board.
917-Expansion Riser Not Detected Expansion (backplane) board not seated properly.
919-Front Panel, MultiPort, and/or
MultiBay Risers not Detected
Riser card has been removed or has not been reinstalled properly in
the system.
1156-Serial Port A Cable Not
Detected
Cable from serial port header to I/O connector is missing or not
connected properly.
1157-Front Cables Not Detected Cable from front panel USB and audio connectors is missing or not
connected properly.
1720 -SMART H ard D rive D ete cts
Imminent Failure
SMART circuitry on an IDE drive has detected possible equipment
failure.
1721-SMART SCSI Hard Drive
Detects Imminent Failure
SMART circuitry on a SCSI drive has detected possible equipment
failure.
1785-MultiBay incorrectly installed For integrated MultiBay/ USDT systems:
MultiBay device not properly seated.
or
MultiBay riser not properly seated.
1794--Inaccessible device attached
to SATA 1
(for systems with 2 SATA ports)
A device is attached to SATA 1. Any device attached to this connector
will be inaccessible while “SATA Emulation” is set to “Combined IDE
Controller” in Computer Setup.
1794-Inaccessible devices attached
to SATA 1 and/or SATA 3 (for
systems with 4 SATA ports)
A device is attached to SATA 1 and/or SATA 3.
Devices attached to these connectors will be inaccessible while “SATA
Emulation” is set to “Combined IDE Controller” in Computer Setup
1796-SATA Cabling Error One or more SATA devices are improperly attached. For optimal
performance, the SATA 0 and SATA 1 connectors must be used before
SATA 2 and SATA 3.
Table A-2. (Continued)
Power-On Self Test (POST) Messages
Error Message Probable Cause

Table of Contents

Other manuals for HP dx7300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP dx7300 and is the answer not in the manual?

HP dx7300 Specifications

General IconGeneral
BrandHP
Modeldx7300
CategoryDesktop
LanguageEnglish

Related product manuals