To Next Page

To Previous Page

Unfolding the monitor

1. Lift the monitor from its box and place it face down on a flat surface.

2. Hold down the monitor stand with one hand (1) then grasp the top of the display with the other hand

and unfold the display head 90 degrees (2).

CAUTION: Do not touch the surface of the LCD panel. Pressure on the panel may cause non-uniformity of

color or disorientation of the liquid crystals. If this occurs the screen will not recover to its normal condition.

NOTE: When the monitor is unfolded for the first time, the display head is locked from adjusting to a full-

height position. To adjust the display head to full height, press down on the display head to unlock it then

pull up on the display head to raise it to the full-height position. Refer to step 3 in

Adjusting the monitor

on page 13.

WARNING! The handle on the rear of the monitor is used to help raise the display to the full-height position.

To lower the display, do not grasp the handle. Doing so may cause you to pinch your fingers between the

display and top of the stand. Press down on the top of the display head to lower the position of the monitor.

6 Chapter 3 Setting up the monitor

Questions and Answers:

Need help?

Do you have a question about the HP E201 and is the answer not in the manual?

HP E201 Specifications

General